Table of Contents

Pulse Sensor (EPS)

Support information & Documents for the EPS Pulse Sensor

Visit the online store page

Model: EPS

 

CTid

Requires the eGauge Sensor Hub and EG4xxx model or newer eGauge. This hardware is not compatible with older model eGauge meters.

 

 

The eGauge Pulse Sensor is used in conjunction with the Sensor Hub and an EG4xxx model meter (Core or Pro) to record pulse output data from devices such as water and gas meters. The Pulse Sensor can accept standard 2-wire pulse outputs or 3-wire 5-volt Hall effect pulse outputs.

 

 

Specifications

  • CTid Enabled (w/ auto-configure and locator LED)
  • Compatible with 2-wire pulse output and 3-wire 5-volt Hall effect pulse output
  • Up to 600Hz max pulse rate
  • 4.7 kΩ pull-up resistor between Signal and 2V
  • Signal pin: open- 2V; closed- 0V
  • -30 °C to 70 °C
  • Humidity range: Up to 80%
  • Extruded aluminum Case
  • 26 x 26 x 40 (mm), 1.02 x 1.02 x 1.57 (in.)
  • 7' RJ-11 cable for Sensor to Sensor Hub
  • 47 CFR Part 15, Subpart B – Unintentional Radiators, Class B for Home or
    Commercial use
  • US Patent # 10560763
  • 2-year limited warranty
 
 

Included Hardware

  • (1) eGauge Pulse Sensor
  • (1) 3-pin input plug
  • (1) 7’ RJ11 cable for connection to Sensor Hub