Visit the online store page
Model: Adam Tech EBH-05-G

Information
This is a replacement part the eGauge meters. Every eGauge meter has a 5-pin plug included with it.
Overview:
Voltage terminal connector block with 5 positions. Accepts three line voltage conductors (L1, L2, and L3) and a neutral conductor. Split-phase installations use the L1, L2, and N terminals. Single phase installations use the L1 and N terminals.

Specifications
- Suggested Torque: 5-in -lb
- Weight: 9 grams
Included Hardware
- One 5-pin power plug
Installation & Assembly
WARNING
- Follow ALL warning and safety procedures when operating with high voltage
- Do NOT apply greater than 277VAC between any line and neutral terminal, and greater than 480VAC between any line and line terminal
- Do NOT attempt to power eGague meters without an appropriate neutral terminal connection
- Pay attention to correct terminals; switching line inputs or neutral connections can result in damage NOT covered by eGauge warranty.
- Connect appropriate voltage measurements to the screw terminals and tighten securely. Do not connect anything to the "Unused" terminal. If wiring a single-phase system, leave the L3 terminal unused.
- Suggested torque for the 5-pin power plug is 5 in.-lb.