How To: Install the Display Caster

Overview

Follow the steps in this guide to install the eGauge Display Caster. Be sure to read the user manual that came with your Display caster as there is information specific to different versions.

Prerequisites

  • Read the Display Caster Manual
  • You will need a mouse and keyboard to configure the Display Caster
  • The default password for the display caster is printed on the paper attached to the manual, as well as inside the box with the eGauge Display Caster. The password can be changed during setup.

Instructions

Step 1: Connect keyboard and mouse via USB.

 

Step 2: Connect HDMI to television or monitor.

 

Step 3: Apply power using the 120V supply adapter, or USB-to-USB cable.

 

Step 3: Configure network, timezone, and device to display and save as default (see Display Caster Manual for software setup information).

  • Do not leave keyboard/mouse, or USB ports accessible in public kiosk display
 

 

Performing a factory reset: 

Connect a keyboard and enter the factory reset code for your version of the display caster. You may need to try multiple key combinations depending on when your display caster was purchased. There is no danger in entering a key combination for a different model.

  • Current model: ctrl+shift+f simultaneously.
  • Previous model: shift+escape, f, r, tab one at a time.
  • Legacy model: ctrl+shift+j simultaneously.

Troubleshooting and Tips

  • Follow the Display Caster Manual for software setup.
  • Ensure the time zone is set correctly.
  • Ensure the default kiosk is saved.

 

Additional Resources