Overview
Follow the steps in this article to connect your EG42xx meter to an existing WiFi network.
Prerequisites
Important!
- eGauge WiFi connectivity is not compatible with captive portal networks where a login screen must be accessed in order to connect.
- Valid login credentials to an existing WiFi network with good reception at the eGauge installation location. You may need to follow up with local IT staff for this information.
Instructions
Wifi connectivity is available on EG4215 and EG4230 model eGuage meters. You will need a WiFi enabled laptop or mobile device to complete this process. Follow the steps below to connect to an existing WiFi network:
Step 1: Be sure the included WiFi antenna is securely screwed into place on the eGauge antenna connector.
Step 2: Press the LCD Toggle Switch to display the Main Menu. This switch can be pressed to make a selection or moved to the side to move the on-screen cursor.
Step 3: Move the switch to highlight Settings and press to select.
Step 4: Move the switch to highlight Wireless and press to enter the wireless settings menu.
Step 5: Move the switch to highlight Setup via AP and press to activate the eGauge Access Point.
The AP will remain active for 60 minutes (3600 seconds). If you wait longer than this time frame to connect, you'll need to repeat the previous steps to reactivate the AP.
Step 6: Use your laptop or mobile device Wifi connection to connect to the AP displayed on the eGauge LCD screen.
Step 7: After you connect to the eGauge Wifi AP, your browser should launch automatically showing the device login screen. Enter the owner account login credentials found on the label affixed to the side of your meter, and click Sign in.
Additional step for Samsung mobile devices!
Additional steps may be needed for Samsung mobile devices. Please see: EG42xx Connectivity for Samsung
Step 8: After logging in you will have the opportunity to connect the meter to an available Wifi network. Click to choose your preferred network and enter the Wifi network credentials and click Save to connect.
Quick Tip!
If you don't plan to connect the eGauge to a Wifi network at this time and would like to continue with configuring the meter, click on the Main menu button in the upper Left of the screen and choose Setup → Other Settings, then continue with the configuration process.
Step 9: Click OK to connect to the local Wifi network, or click Cancel to go back and choose another network. When the eGauge connects to the local Wifi network, the AP function will end and you will lose connectivity to the meter. Check the eGauge LCD screen for progress.
You should now be able to connect to the device via its eGauge proxy URL or at its local IP address on the LAN and continue with the configuration process.