TP-Link powered USB WiFi Bridge Setup (TL-WR802n)

 

Tips for Troubleshooting:

Setup instructions

Do not connect Ethernet to the TP-Link bridge before the setup via WiFi is complete. If an eGauge meter or other device is connected via Ethernet to the TP-Link bridge, the initial setup will not work.

2) Using a laptop with WiFi, connect to the wireless network broadcasted by the TP-Link bridge. The SSID and password are located on a card that comes with the wireless bridge. This information is also printed on the bottom of the bridge itself.

3) When connected to the wireless bridge's network, open a web browser to http://tplinkwifi.net/. Log in using the default login printed on the card that comes with the wireless bridge.


4) Choose "Next" to begin the Quick Setup.


5) You may choose to change the admin password in this step. Choose Next when done.


6) Choose "Client" as the operation mode and press Next.


7) A list of in-range WiFi networks are displayed. Choose "Connect" next to the network you will connect the eGauge to.


8) Enter the password for the WiFi network and choose Next.



9) Choose "Smart IP" for the LAN type. This will automatically assign the admin interface an IP address from the main network, and any eGauges connected to the Ethernet port will obtain an IP address from the main network. Press Next to continue.


7) You can review the configuration and press Finish to save and reboot.


Below shows the setup of an eGauge connected to a TP-Link TL-WR802N bridge connected in client mode on a WiFi network. The network uses the 172.17.2.* network. The WiFi bridge was assigned 172.17.2.180 while the eGauge was assigned 172.17.2.182:


Please visit kb.egauge.net for the most up-to-date documentation.